Dense phase conveying systems

The dense phase conveying systems manufactured by CAMImpianti have been planned for the processing of a large range of fluidizable products, both in powders and in granules, that are brittle and/or abrasive, or else in any case in which it is necessary to convey the product at low or medium speed.
The configuration of the system shows different levels of complexity, from the propulsion system, advised for easily conveyable products, to the emptying system, with fluidization in the machine and in line,up to the fullline plant, that always works with a full pipe, thus allowing a very low transportation speed.
We also manufacture propulsion systems located on loading cells, for the conveyance of pre-weighed batch, as well as launching equipments with two parallel systems, if you require a transportation that is continued and not batch-based.

- in carbon steel
- in AISI 304 or AISI 316 stainless steel

The system includes the pneumatic scheduling board and the control of compressed air, and it can be managed from an independent electric panel with a schedulable control device, or, from the general processing board.
Product rate, speed and air consumption depend mostly from the conveyed product and from the path of the line;

Machinery above described could be supplied also in ATEX version if required.

Indicazioni stradali

We and selected third parties use cookies or similar technologies for technical purposes and, with your consent, also for other purposes as specified in the cookie policy.
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.